| dc.description.abstract | In the last years, the Brazilian construction industry is among those of national production sectors that have been having a great growing, mostly due to the incentive from the government and due to financed resources by private and public agents. This industry is also one of the major consumers of natural resources and energy, besides being the main generator of solid waste. One of these natural resources used in the constructions is sand. An environmentally friendly and economical alternative to reduce the extraction of natural resources is the use of recycled waste. The associated use of low volume of raw materials with alternative materials, like waste, is one of the ways to get more sustainability in the construction sector. Construction and building components made with autoclaved cellular concrete (ACC) employ four times less material than others with the same function. Other advantage of ACC is the performance of its properties like compressive strength, thermal and acoustic behavior, lower density, fire resistance. The aim of this research was to investigate the use of fine grains from recycled concrete aggregate (ARC) as partial sand replacement in the production of autoclaved aerated concrete. With the goal to find the mix proportion some pilot studies were made. After this, it was chosen a relation of 67% of cement and 33% of natural fine aggregate (sand). The lime was used in the amount of 0.45% of total cement and sand, and 0.3% of aluminium. The water to total solids ratio was 0.32. It was employed Portland cement type V according to Brazilian standards, calcitic lime, natural sand and ARC passing in sieve with 150 micron opening. The replacement rate of sand by ARC was 0%, 25% and 50%. From 24 hours after the mixing of materials, the samples were submitted to steam curing in an autoclave chamber for 6 hours. It was evaluated the compressive strength, the density, the capillary water absorption and porosity. The compression strength tests were performed at 48 and 72 hours. Water absorption tests were conducted for 96 hours after samples preparing. The capillary porosity was calculated with the capillary water absorption data. ACC's microstructure analysis was done by scanning electron microscopy (SEM). The results showed in general that the behavior of ACC produced with ARC differs significantly from the ACC produced with natural aggregate. When the ARC rate increases the apparent specific gravity also increases as well as the compressive strength. The observed increase in the apparent specific gravity is not desired. However this behavior of ACC done with RCA does not prevent the use of this recycled aggregate. An optimized study of pre-wetting of RCA could improve its performance as aggregate for use in ACC, once its grain size showed to be appropriated for this kind of use. | pt_BR |
